SureTrack Community Fix: A Jarring Situation

Real Fixes from the SureTrack® expert information resource are documented issues from actual shop repair records and community discussions. Read on to see how SureTrack can help you correct issues that are not easily diagnosed using OEM information alone. SureTrack is available at no additional cost in our ProDemand product.


All modern vehicles will drain a battery when sitting but when it happens in a short time, it’s time to investigate. SureTrack community member after6tuning had a Kia Soul that had a parasitic draw issue and they found some charging issues which they corrected but didn’t eliminate the draw. They posed the question to the community, and with the help of fellow community member todawg and others, they were able to resolve the issue quickly.

The following Community Fix summarizes the interaction between members of the community that led to the solution.

Vehicle
2011 Kia Soul Sport 2.0L

Title
No start, replaced door ajar switch.

Complaint
Car came in on the hook with the battery dead. Customer replaced battery two weeks prior. Charged up and noticed voltage at idle was about 12.8v or so. Put new, not remanufactured 90 amp alternator in and has good voltage until the A/C is turned on with the headlights. When they are turned on, voltage drops to 12.8v, however this is not at first, it takes a moment of running to come down. If you raise the RPMs it immediately goes to normal high 13-14v. I noticed that when I measured voltage at alternator B+ cable it would read about .3v higher than when measured at battery terminals.

Diagnostic Steps Performed/Parts Replaced Voltage drop at battery cables. Cleaned 2 PCM grounds and battery ground. Positive to alternator voltage drop was excessive at .3v+. Ran brand new 4ga battery cable from battery to fuse box, and fuse box to alternator. Even added additional ground to engine directly from battery. Voltage drops have reduced significantly however the battery voltage measured at the alternator vs the battery posts is about .3v more. So example alternator has 13.1v and the battery measures 12.8v, even with new cable and terminals. Why am I getting .3v less at battery vs alternator. Is it normal for this alternator to only have battery voltage at idle when A/C is on high and headlights on? I thought it should be at least in the 13s.

Best Answer from Community Member todawg A .3 volt drop is right at the limit. Do a voltage drop test to figure out where the drop is at. Fuse box? Ground? 12.8 volts at idle seems low. The PCM controls the alternator. With a scan tool look to see what the PCM is telling the alternator to do. It normally sends a duty cycle to the alternator.

Cause
These alternators are only 90 amp and not very strong, so idling with A/C and headlights on it’s barely charging. Confirmed this by testing another Kia Soul at the local dealer. Now to the original issue that the car came in for which was the battery was dead. Her daytime running lights (DRL) would stay on intermittently causing a drain. I also noticed the interior lights sometimes wouldn’t come on when the driver’s door was opened. I barely touched the driver’s door ajar switch and the interior light came on and the DRL parking lights went off. I got a new switch from Kia and all is well. Customer is happy.

Correction
Replaced door ajar switch, charged battery and parasitic draw was eliminated. Customer’s complaint did not return.


SureTrack® adds to the power of ProDemand® with an exclusive combination of real-world knowledge and powerful diagnostic tools, all wrapped in an interactive community of professional technicians. Designed to help automotive shops increase accuracy and efficiency from diagnosis to completed repair, the industry’s most comprehensive repair information resource is just a few clicks away.

Want more? Here’s how you can see more Real Fixes in SureTrack:

About the Author

Nick Taylor

Nick Taylor is the SureTrack Community Administrator and a Senior Applications Specialist at Mitchell 1 with over 25 years of experience with electronic repair data systems. Nick previously worked in the automotive dismantling and engine rebuilding industries.